Search results for '1911 grip'

Full sized vertical grip
Contoured finger swells allow a firm grip even with gloved hands
Secure watertight storage compartment
Customizable foam storage block with quick access tab diminishes rattle
Flat non-slip bottom surface aids in supported firing positions

Over a dozen configurations!

Modern handguard grips have come a long way. They enhance the shooters skills through better recoil management and ease of indexing repeatability for speed.  But one grip style may not be suited for everybody, and sometimes rail space is limited so just a hand-stop can fit. But what if you didn't have to settle for just onegrip style?

Introducing the Strike Industries Hand Stop Kit. Gone are the days of having to keep extra handstops, foregrips, and other grip accessories laying around. Including 3 sections that can work together or as standalone attachments, there are over half a dozen ways to configure the Link hand-stop kit for different shooting styles.The three sections are made from durable, reinforced, & heat-resistant polymer. Each section uses a single modified T-nut that has been tried and tested for superior lock-up. The HSK is directly mounted to either M-Lok slots or Keymod holes without the need for adapters in between, resulting in a highly ergonomic and secure lock-up. 

Don’t compromise­–overcome, with the Link Handstop Kit.   

COMPATIBILITY: M-LOK and KeyMod Rails
NOT COMPATIBLE: HAYL Rail M-LOK Handguard for Benelli M4

DISCLAIMER: LINK screws and nuts provided are not manufacturer by Strike Industries. Please make routine checks that the screws and nuts are secure as part of the preventive maintenance of the firearm.

Torque: Do not exceed 20 in/lbs (2.26 nM) for the LINK screws

Combination vertical grip and illumination mount
Accommodates 3/4" - .825" - 1" diameter light/laser
Lock-out switch prevents unintentional activation of light source
Grooved gripping surfaces to eliminate hand slippage
Pressure pad wells allow light activation for RH Operators
Thumb activation switch for wireless light activation
Secure watertight storage compartment
Customizable foam storage block with quick access tab diminishes rattle
Flat non-slip bottom surface aids in supported firing positions

Quick detach vertical grip
Grooved gripping surfaces to eliminate hand slippage
Secure watertight storage

The Strike Industries Magwell for CZ Scorpion EVO is a flared design specifically for Scorpion EVO pistols and carbines to provide easier magazine insertion for fast reliable reloading while adding SI styling. The benefit of adding a funnel-like magwell to help prevent the dreaded reload bobble outweighs the added material of this lightweight SI Magwell. With the addition of an increased radial edge in front of receiver, this magwell aids in improving grip support for the offhand. This magwell is made of high-strength impact resistant custom blended SI Polymer Extreme material. Add consistency and cut fractions of seconds off your reloads now with the Strike Industries Magwell for CZ Scorpion EVO. A perfect pairing with the SI Mag Release For CZ Scorpion EVO.

COMPATIBILITY: All CZ Scorpion EVO models (except 3+)
NOT COMPATIBLE: CZ Scorpion EVO 3+

WARNING: DO NOT OVERTIGHTEN set screw when installing. Tighten only until end of set screw is flush with the nut. Failure to properly install will result in magazine not dropping freely.