Search results for 'free float rail'

The Strike Industries Magwell for CZ Scorpion EVO is a flared design specifically for Scorpion EVO pistols and carbines to provide easier magazine insertion for fast reliable reloading while adding SI styling. The benefit of adding a funnel-like magwell to help prevent the dreaded reload bobble outweighs the added material of this lightweight SI Magwell. With the addition of an increased radial edge in front of receiver, this magwell aids in improving grip support for the offhand. This magwell is made of high-strength impact resistant custom blended SI Polymer Extreme material. Add consistency and cut fractions of seconds off your reloads now with the Strike Industries Magwell for CZ Scorpion EVO. A perfect pairing with the SI Mag Release For CZ Scorpion EVO.

COMPATIBILITY: All CZ Scorpion EVO models (except 3+)
NOT COMPATIBLE: CZ Scorpion EVO 3+

WARNING: DO NOT OVERTIGHTEN set screw when installing. Tighten only until end of set screw is flush with the nut. Failure to properly install will result in magazine not dropping freely.

The Strike Industries Magazine Release for the CZ Scorpion EVO is a lightweight, high-strength polymer solution that enables the user to depress the magazine release utilizing only one hand. Whereas the original design requires two hands to disengage a magazine, the Strike Industries Magazine Release has added fins on both sides of the trigger guard that allow the shooter to use their shooting finger to hit the release, freeing the other hand of that burden and allowing for overall faster reloads. Quicker reloads lead to more rounds on target in a shorter amount of time.

The Strike Industries Angled Vertical Grip with Cable Management (M-LOK) is engineered like no other grip on the market. The grip angle sits on the handguard at 86 degrees. Patent pending SI cable management function enables you to organize and store excess wire from your weapon light or any other cabled accessories in multiple configurations. Instead of tucking wire anywhere you can and using cable ties or tape to hold it down, the cable management feature will offer you a place to route and/or contain loose wire inside the grip cavity. The side cuts at the top middle of the grip allow for easier pressure switch attachment. Compared to the Short version, the Long version has an added built-in stability feature when you place the L-shaped bottom onto a table edge/corner or as a barricade stop, giving you another way to get back on target faster downrange. The Short version can be mounted in either direction for your own preferred and personal setup and is low-profile form helps to minimize snags. The forward angle provides more of a natural wrist angle and increased rigidity of forearm. Designed with textured palm and finger areas with flat sides for positive handling and easier manipulation of the firearm. Made from durable and lightweight polymer compatible with M-LOK rails, the Strike Industries Angled Vertical Grip with Cable Management (Long) gives the shooter control while handling or firing the weapon, added stability (Long) with table/edge corner or as a barricade stop and an innovative way to ensure total cable management. No messy wires.

COMPATIBILITY: M-LOK

DISCLAIMER:
-Always check with your state and local laws. We are not lawyers.
-LINK screws and nuts provided are not manufacturer by Strike Industries. Please make routine checks that the screws and nuts are secure as part of the preventive maintenance of the firearm.

Torque: Do not exceed 20 in/lbs (2.26 nM) for the LINK screws