Search results for 'Hand guards ptw'

Strike Industries LINK attachment system takes the age old question Key-Mod vs. M-Lok and came up with the ultimate solution, a dual interface design compatible with both M-Lok and Key-Mod, same hardware with no need for additional parts. This Aluminum rail section allows the attachment of various M1913 Picatinny spec rail-mounted accessories such as vertical grips, lights, lasers,  etc. The Dual interface rail section also features beveled ends to reduce snagging and eliminate sharp corners and edges.  

The Strike Industries Magwell for CZ Scorpion EVO is a flared design specifically for Scorpion EVO pistols and carbines to provide easier magazine insertion for fast reliable reloading while adding SI styling. The benefit of adding a funnel-like magwell to help prevent the dreaded reload bobble outweighs the added material of this lightweight SI Magwell. With the addition of an increased radial edge in front of receiver, this magwell aids in improving grip support for the offhand. This magwell is made of high-strength impact resistant custom blended SI Polymer Extreme material. Add consistency and cut fractions of seconds off your reloads now with the Strike Industries Magwell for CZ Scorpion EVO. A perfect pairing with the SI Mag Release For CZ Scorpion EVO.

COMPATIBILITY: All CZ Scorpion EVO models (except 3+)
NOT COMPATIBLE: CZ Scorpion EVO 3+

WARNING: DO NOT OVERTIGHTEN set screw when installing. Tighten only until end of set screw is flush with the nut. Failure to properly install will result in magazine not dropping freely.

The Strike Industries M-LOK Cable Management Covers add a positive tactile feeling but also utilizes the patent pending SI Cable Management System® (CMS) function enables you to organize and store excess wire from your weapon light or any other cabled accessories. Instead of tucking wire anywhere you can and using cable ties or tape to hold it down, the SI CMS will offer you a place to route and/or contain loose wire inside the cover cavity. Cables can be routed alongside the handguard, across to the other side, 90-degrees or U-shape. The directions and possibilities are almost endless. Designed to be low-profile (6.20mm (0.24”) height) and used in any orientation, the contoured covers add ergonomic textured surfaces to your handguard. Made of durable and lightweight polymer, the covers are also a quick and affordable upgrade to mitigate any heat transfer between the barrel and the shooters hands while organizing and routing cables just about any way you want. Available in a Long version that is 79.80mm (3.14”) in length that comes in a 2-pack or a Short version that is 39.90mm (1.57”) in length that comes in a 4-pack. Get one length or both and always have the Strike Industries M-LOK Cable Management Covers you need to get a grip and manage your cables at the same time.

COMPATIBILITY: M-LOK

NOTE: LINK screws and nuts provided are not manufacturer by Strike Industries. Please make routine checks that the screws and nuts are secure as part of the preventive maintenance of the firearm.

Torque: Do not exceed 20 in/lbs (2.26 nM) for the LINK screws